In this installation tutorial, we are breaking down the step-by-step process for retrofitting an Electric Power Tailgate Lift System on the Mercedes-Benz E-Class W213. We’ll walk you through removing the trunk liner trim, swapping out the stock gas struts for motorized power shafts, routing the CAN-bus signal harness, and mounting the tailgate control switch. You'll gain full push-button control straight from your factory key fob, driver-side cabin switch, or tailgate inner button.
If you're planning a DIY weekend project for your personal car, or if you run an auto retrofitting shop looking to stock these high-demand upgrades for your local market, hit the link below for full product specs, fitment verification, and wholesale inquiries.
Product link: Mercedes Benz Electric Tail Gate Lift, Hand-free Access Trunk
1, Remove the trunk cover
2, Remove the plastic board as picture show
3, Remove the springs of both side,, add the revet (as picture show position)
4, Install the product bracket
5, remove original plastic buckle install product bracket and ball head
6, Fasten the ball head bracket
7, Remove original lock, install suction lock board (before removing
original lock, use pen to mark the lock position)
8, Install suction motor, pull cable go through position as picture show
9, Negative cable connect to GND
10, Remove the screws as the arrow show, take out fuse box
11, Product red signal cable connects to original brown red cable, orange signal cable connects to brown cable
12, open the buckle as arrow show and take out fuse box
13, Take out the screws of power cable and connect product power cable
14, Expand hole at this position
15, Install the button
Audi
BMW
Mercedes Benz
BYD
BAIC MOTOR
Cadillac
Chery
Denza
Ford
Geely/ZEEKR
Honda
Hyundai Kia
Jaguar
Jetour
Jeep
Lamborghini
Land Rover
Lexus
Li Auto
Mazda
Nissan
Porsche
Tesla
Toyota
Volkswagen
Volvo